Drawmer-electronics MC2.1 Monitor Controller Manual de usuario

DRAWMERCONTENTSWarrantySafety ConsiderationRadio Frequencies StatementChapter 1 - IntroductionIntroductionInstallationPower ConnectionPortable Applina

10DRAWMERCONTROL DESCRIPTIONAs well as a transparent and precise signal path the MC2.1 Monitor Controllerincorporates many impressive features which a

11MC2.1 - Monitor ControllerThe MC2.1 ControlsSOURCEThree switches select which of I/P1, I/P2 and AUX is heard (see ). Each can beoperated indiv

12DRAWMERMix Checking cont...Under the Cut heading three switches have been incorporated - Left Cut, Mute andRight Cut.Left Cut: Mutes the Left chann

13MC2.1 - Monitor ControllerTalkback Level. The knob adjusts the gain level of the talkback microphone. It canbe adjusted to compensate for the distan

14DRAWMERINPUTSThe MC2.1 has four inputs comprising a I/P1 - a balanced Neutrik XLR, I/P2 - abalanced Neutrik XLR/jack combi (combining a 3 pole XLR r

15MC2.1 - Monitor ControllerMAINS I.E.C. AND POWER SWITCHThe mains inlet, I.E.C., which also incorporates the internal mains fuse, can befound on the

16DRAWMERMONITOR CALIBRATIONWhether you are installing one, two or three sets of speakers it is imperative thatyour system is calibrated, not only to

17MC2.1 - Monitor ControllerHolding the SPL - Set the meter to C weighted and on the slow scale. Start by sittingin your normal mixing position, hold

18DRAWMERThe Procedure:1. Begin by turning off the monitoring system and ensuring that all inputs andspeakers are correctly connected.2. Set all DA

19MC2.1 - Monitor Controller11. On the underside of the MC2.1 rotate the Right A trim clock-wise until the SPLmeter reads the desired level.12. To cal

2DRAWMER

20DRAWMERMix Checking TipsDue to the versatility of the MC2.1, and it’s thorough array of controls, some veryuseful techniques for checking your mix c

21MC2.1 - Monitor ControllerCut It Out...Using the left and right cut switches will highlight the stereo balance of eachchannel. In stereo the mix sou

22DRAWMERListening in mono also highlights problems with the stereo width and balance ofthe mix and is more apparent when you use a lot of stereo-wide

23MC2.1 - Monitor ControllerCHAPTER 3SPECIFICATIONNote: These specfications are provisionaland may alter slightly upon productrelease.INPUTMaximum Inp

24DRAWMERRef:1v01E 08-04-14BLOCK DIAGRAM

3MC2.1 - Monitor ControllerCOPYRIGHTThis manual is copyrighted © 2013 by Drawmer Electronics Ltd. With all rights reserved. Under copyrightlaws, no pa

4DRAWMERCHAPTER 1With the Drawmer MC2.1 Monitor Controller incorporated into your system youcombine the clarity, fidelity and transparency of the high

5MC2.1 - Monitor ControllerWhether you’re mastering a cd/dvd, recording, checking a mix for balance and e.q,doing A/B comparisons, plus a multitude of

6DRAWMERINSTALLATIONThe MC2.1 is a free standing, desktop unit, with controls and headphone jacks onthe front panel and all other inputs and outputs o

7MC2.1 - Monitor ControllerThe MC2.1 unit will be supplied with a power cable suitable for domestic poweroutlets in your country. For your own safety,

8DRAWMERAUDIO CONNECTIONS• Interference:If the unit is to be used where it maybe exposed to high levels of disturbancesuch as found close to a TV or r

9MC2.1 - Monitor ControllerTYPICAL CONNECTION GUIDE